Skip to Content

Android app

How to use the kiosk on an Android tablet with a scanner connected through USB-OTG, and how to turn on full screen and kiosk mode.

When you need this

The kiosk runs on an Android tablet or phone in the dedicated EduMeal Kiosk app, and the scanner is connected through USB-OTG. A normal Android browser cannot see such a scanner, so you need the app.

  1. Install the app provided by the school admin and open it with the internet on. The first start without a network is impossible. After that the same screens as in the browser apply: registration, sign-in, serving.
  2. Connect the scanner to the tablet through a USB-OTG hub or adapter. The scanner must work in serial-port mode; you do not need to switch it to keyboard mode or focus the code field.
  3. When Android asks for USB permission for the first time, allow it. It is a one-time system prompt.
  4. Scan a student QR code. Serving then goes as usual, see Serve a student.
  5. To hide the Android system bars, open Tools, and in the Full screen block press On. To turn it off, press Off in the same place. The tablet is not locked.
  6. To lock the tablet on the kiosk, press On in the Kiosk mode block. After that the tablet opens the kiosk by itself at start, the Home and Recents buttons do not leave it and Back does nothing. If the tablet was not prepared by an admin, Android asks whether to make EduMeal Kiosk the home app and whether to pin the screen: accept both prompts.
  7. To leave kiosk mode, press and hold Off for 3 seconds. A short tap does nothing. The same Turn kiosk mode off button is on the sign-in and registration screens, in case the session has ended.

What you will see

The app works like the normal kiosk. After the first opening with the internet, like the browser version, it can work without a network thanks to the saved session.

If something goes wrong

  • Scans do not arrive: close and reopen the app so that Android asks for USB permission again. If you unplugged the scanner or the hub, plug them back in: the app picks the scanner up by itself.
  • If the school enabled serial scanner support, the Scanner status block has the Connect Serial Scanner, Disconnect and Retry buttons.
  • A "No connection" screen with a "Try again" button: the app cannot open the kiosk and has nothing saved. Connect the tablet to the internet and press the button.
  • You see Full screen was not changed or Kiosk mode was not changed: the tablet refused the change, and the switch shows the real state.
  • Kiosk mode prevents leaving by accident, but it does not protect against a person who knows about the held button. Do not leave the tablet unattended.
  • The app asks you to update the system WebView component, or says it is set up incorrectly: contact the school admin (School kiosks).

On this page